QUESTIONS AND COMMENTS
We value you as a customer and your satisfaction with this product is important to us. If you have any comments or questions, or you find any parts of
this kit missing or defective, please contact our distributor in your country, whose address is printed on the packaging. You are also welcome to contact
our marketing support team via email: [email protected], fax (852) 25911566, telephone (852) 28936241, or our website: WWW.4M-IND.COM.
9.
Align
each notch with the small cutout on parts (C, I,
J1,
and
J2)
as shown in the small diagram. Insert (J2)'s 3
joints
into the holes on
the pump base to secure the completed
cylinder
in place. Water will flow
smoothly
through the
system only
if the pieces are connected
correctly. Finally, connect the main frame to the pump base as shown.
10.
Use
pegs to connect the piston and small motor
joint
to the piston connector.
The
small motor
joint
should be inserted from the flat
side of the piston connector. Remember to lubricate the areas identified by the oil symbol.
11. Connect the small motor joint to the gearbox and then slide the piston into the cylinder.
12. Create a secure connection between the piston and
cylinder
connector
by
inserting a peg as shown.
Remember
to lubricate the
areas identified by the oil symbol.
13. Connect the arms, figure
body
and large gear
joint
together with a peg. Clip the legs to the figure
body. Punch
out two faces from
the product's packaging and push them into the head.
14. Insert the figurine connector into the bottom of the
battery
case.
Slide
the large gear
joint
onto the gearbox and figure onto the
joint
connected to the battery case.
3. Insert the joint into the socket as shown.
4. Clip the solar panel into the battery case's joint.
Remark: The
oil drop symbol indicates the areas which may
require
lubrication. It is recommended that you apply some cooking oil or
lotion to the joints or moving parts when assembling the product. This helps to reduce friction and enhance mechanical performance.
5.
Lubricate
the motor head and shaft with cooking oil or lotion before inserting it into the gearbox with the wires facing you.
Place
the
motor cover over top allowing for the wires to come out of the cover's slot. Secure with two small screws.
6. Slide the gearbox and battery module into position.
7.
Secure two black wires in the left terminal, two blue wires in the middle terminal and three red wires in the right terminal with a
terminal cap.
8. Check this diagram to ensure you have connected the wires correctly.
©2019 4M INDUSTRIAL DEVELOPMENT LIMITED. ALL RIGHTS RESERVED.
BLUE
BLUE
RED
RED
BLACK
