Figure 1
Figure 2
Figure 3
Figure 4
Note: The calibration must be completed only when the aircraft is placed on a horizontal plane.
Note: This function operation is only suitable for the aircraft in an uncontrolled state. Under normal
circumstances, it is recommended to use the one-key takeoff/one-key landing key.
10.3 Horizontal calibration operation:
Long press the calibration key on the remote controller, and the LED lights on the aircraft will flash.
When the LED lights on, calibration of the aircraft is completed, the remote controller emits "beep"
(Figure 1).
10.4 Start/stop
Push the left control lever on the remote control upward (Figure 2). At this time, the aircraft can take off
normally. After taking off, all the indicator lights of the aircraft will always be on. During the flight, whether
you short press the key, the aircraft will stop flying (Figure 3).
10.5 One-key take-off and landing
When unlocking is complete, gently press the “One Key Takeoff/Landing” key on the remote control
(Figure 4), the aircraft will automatically rise to a height of about 1 meter to maintain a stable flight; when
you press this function key gently again, the aircraft will automatically land slowly.
Operate the aircraft with the remote control. Before taking off, please operate according to the
above sequence: Turn on (refer to 10.1)→ frequency matching of the remote control starts
(refer to 10.2)→horizontal alignment (refer to 10.3)→ start/stop (refer to 10.4)→ one-button
taking off and landing (refer to 10.5)
Warning
06
