IMPORTANT:
Exposure to harsh weather conditions may encourage rusting of the steel metal components.
Protection from these conditions is recommended.
Plug the seat back’s center bar (I) into the hole of center bar
(H) on seat bottom. Tighten the bar with bolt (1) washer (5)
and nut (6).
Then fix the seat back with arm side frames with bolt (2) the
outside, washer (5) and nut (6) on the inside. Assemble as
shown.
Step 7
Carefully line up the holes in arm cover (J) with holes on
arm frame (E/F), using a quick downward push, snap cover
over frame. Attach arm holder to each side frame with the
bolt (4). Then washer (5) and round top nut (7) should be
used underneath the arm cover. Assemble as shown.
Step 8
page 6
A
B
H
E
F
E
F
J
J
3
2
Item
Drawing
Qty
5
2
7
2
6 5
5 1
65
2
2
65
I
3
5
7
3
5
7
1
2
Item
Drawing
Qty
5
8
6
6
2
4
ATTENTION : DO NOT TIGHTEN ALL OF THE NUTS UNTIL THE FINAL STEP IS COMPLETED. IMPORTANT TO FULLY TIGHTEN BEFORE SITTING ON CHAIR.