4CR 6.9752.0003, Руководство по эксплуатации

Страница: 7 / 11

5. Operation
1. Connect the electricity. The supply cable must be at least 4mm ² at 230V.
Make sure the supply voltage and frequency are as specified correspond to the type
plate of the device.
2. Switch on the device, symbols are displayed.
3. Set the distance between the device and the workpiece. Usually a distance of 30 – 60
cm is to be kept.
4. Select drying mode. (Pulse drying achieves a better gloss)
5. Set time and temperature according to the manufacturer’s specifications of the
applied materials to achieve the desired result .
Watch out! Device heats up during use. Injury and fire hazard!
Switch off the appliance after use. Store the device in a safe place to avoid
damage.
5
Mount device
Connect power
supply
Turn on
Digital display
Choose a drying
mode
Set temperature
and time
Place the heat source at
a distance of 30 – 60 cm
parallel to the surface
Turn off
30-60cm