background image

M2479(B)    646-041                                                                         iss012411 >: M3005-CA-man

When this product is incorporated into other machinery or apparatus, that apparatus must

not then be put into service (in the E.C) until it has been declared in conformity with the

appropriate E.C Directive/s.

Specification

Supply: ................................. 12-240V dc or 24-240V ac.

Supply Rating .......................2VA.

Output .................................. S.P.C.O. Relay

Switching Capacity: .............. 3A 240V non-inductive maximum.

Ambeint Temp: ..................... -15°C to +50°C.

Output State: ........................Normally open. Closed above set speed.

Calibration: ........................... Automatic. Initiated by magnet

supplied.

Sensing Range: .................... Nominally 12mm  on ferrous metal &

5mm on non-ferrous metal at 25°C.

Input Pulse Range: ............... 10 to 3600 p.p.m.

Repeat Accuracy: ................. 1%.

Start Up Delay: ..................... Adjustable to 0 - 30 seconds.

Operation Setting ................. Automatic calibration by  applying

magnet to 'Cal' point.  Relay de-

energises at 20% under set speed .

Enclosure: ............................ Moulded Nylon. DIN threaded 30mm by

1.5mm pitch.

Protection: ............................IP65.

Relative Humidity: ................ 90% RH.

LED Indication: ..................... Target Detected & Output.

Cable ........................

Supplied with 2 metres 5 core

600/1000V flame retardant to EN60332-1.

SLIPSWITCH

Type M3005V10CA

CSA & ATEX APPROVED,

SELF CONTAINED

UNDERSPEED MONITOR

Manual No: M2479

INSTALLATION

INSTRUCTIONS

UNDERSPEED MONITOR - M3005V10CA

PROGRAMMABLE  UNDERSPEED MONITOR

M300 

(CSA & ATEX Approved)

TECHNICAL INFORMATION

Baseefa Approval

CSA Approval

Page  8  of  8

Page  1  of  8

4B  COMPONENTS

729 Sabrina Drive, East Peoria, Illinois 61611 USA
Tel: 309 -698 -5611
Fax: 309-698-5615
e-mail: [email protected]
Web: www.go4b.com

4B  BRAIME ELEVATOR

COMPONENTS

Hunslett Road, Leeds, LS10 1JZ England
Tel: +44 (0) 113 246 1800
Fax: +44 (0) 113 243 5021
e-mail: [email protected]
Web: www.go4b.com

4B  SETEM

9 Route de Corbie, 80800 Lamotte Warfusée. France
Tel: +33 (0) 3 22 42 32 26
Fax: +33 (0) 3 22 42 37 33
e-mail: [email protected]
Web: www.go4b.com

Содержание SLIPSWITCH M300







Отзывы: