3Ware 9500S-4LP - Escalade RAID Controller, Руководство по установке

Страница: 58 / 126

Configuring Units
50 3ware 9000 Series Serial ATA RAID Controller Installation Guide
If you want to use a RAID configuration which has started
initializing, press
Esc to cancel the progress box. You can then exit
3BM and boot to the operating system before the process of writing
zeroes to the drives is complete. Once you have booted to the
operating system, initialization of the RAID 5 or RAID 50 unit will
begin after a delay of up to ten minutes.
When initializing is done after booting to the operating system, the
process of initializing takes longer than it does if initialization is
done by writing zeroes to the array in the BIOS. Consequently, it
will be a longer period of time until the performance of the unit is
fully optimal. Data remains intact when initialization is done in the
operating system.
For RAID 1 and RAID 10
RAID 1 and RAID 10 units are not initialized when they are created
and are immediately available for use with full performance when
created.
Initialization of RAID 1, RAID 10, RAID 5 with 3 or 4 disks,
RAID 50 with 6, 8, or 9 drives, and RAID 50 with 12 drives
configured in 3 subunits of 4 each or 4 subunits of 3 each will take
place the first time the array is verified, either via 3BM, through
3ware 3DM 2, or through the 3ware CLI. The steps below describe
how to do this through the BIOS (3BM). For information about
using 3DM 2, see
3ware 9000 Series Serial ATA RAID Controller
User Guide . For information about using the CLI, see 3ware
Escalade 9000 Series Serial ATA RAID Controller CLI Guide .
To start initialization through Verify in 3BM
1 Reboot and restart 3BM.
2 Select the array you want to verify. (Highlight it and press
Enter .)
3 Tab to Maintain Array and press Enter .