When the sensor is connected, you should be able to see the following data:
Fig. 22 Main menu of sensor configurator
1) Sensor’s serial number
2) FW version
3) Network address of the sensor (its ID used for the RS485 connection)
4) Status message with the sensor’s current status
5) Current readings of the sensor
6) Current mode of the sensor, range of the output data (1-1023 or 1-4095) and
filtration type and level
Sensor calibration
After you cut or extended the length of the sensor’s tubes, you need to
recalibrate it.
You can do the calibration without fuel to do so you need to enter the sub
menu
“Sensor calibration”
(Fig. 23).
19
Содержание TD-150
Страница 6: ...6...
Страница 15: ...Fig 13 Additional files Fig 14 Windows components and libraries Fig 15 RuntimePack is installed 15...
Страница 50: ...Fig 61 2 Setting Full and Empty values manually Fig 61 3 Setting Full and Empty values manually 50...
Страница 54: ...Fig 65 Sealing cable connection point Fig 66 Sealing sensor old design 54...
