Click “Login” button to login to the WEB interface of
the device.
Note:
The device has no IP address by default, so you can
search and configure the IP address of the device
through PROFINET configuration software such as
STEP 7 and TIA Portal. Or use the command line to
configure the IP address of the device through the
CONSOLE port. If the IP address of the device is
configured to 192.168.1.254, the command line
operation is as follows:
User: admin
Password: admin
Switch> enable
Switch# configure terminal
Switch(config)# ip address 192.168.1.254/24
The default user name and password of the device are
“admin”.
If the username or password is lost, user can restore it to
factory settings via device DIP switch or management
software; all modified configurations will be cleared
after restoring to factory settings, so please backup
configuration file in advance.
Please refer to user manual for specific configuration
method of logging in to WEB interface and other
configurations about network management function.
【
Specification
】
Panel
Gigabit SFP
1000Base- X, SFP slot
100M copper port
10/100Base-T(X), RJ45,
Automatic Flow Control,
Full/half Duplex Mode,
MDI/MDI-X Autotunning
Console port
CLI command management
port (RS-232), RJ45
Alarm interface
2-pin 7.62mm pitch terminal
blocks, support 1 relay alarm
output, current load capability is
5A@30VDC or 10A@125VAC
Indicator
Power supply indicator, run
indicator, interface indicator,
alarm indicator
Switch Property
Backplane bandwidth
12.8G
Packet buffer size
3Mbit
MAC Address Table
8K
Power Supply
Input power supply
Voltage range: 12~48VDC.
Support dual power supply
redundancy, non-polarity and
anti-reverse connection
Support built-in 4.0A
overcurrent protection
Access terminal block
4-pin 7.62mm pitch terminal
blocks
Power Consumption
No-load
5.28W@24VDC
Full-load
11.06W@24VDC
Working Environment
Working temperature
-40
℃
～
75
℃
Storage temperature
-40
℃
～
85
℃
Working humidity
5%
～
95% (no condensation)
Protection grade
IP40 (metal shell)