Provide 1 program debugging port based on RS232 serial port
which can conduct device CLI command management after
connecting to PC. The interface adopts RJ45 port, the RJ45
pin definition as follows:
Pin No.
2
3
5
Definition
TXD
RXD
GND
【
Antenna Connection
】
Model III and IV provide 2 WIFI antennas, the antenna
specifications are shown below:
Type
P/N
Gain (dBi) Quantity (pcs)
2.4G
wireless
3005040056
5
2
【
Checking LED Indicator
】
Provide LED indicators to monitor its operating status, which
has simplified the overall troubleshooting process. The
function of each LED is described in the table below:
LED
Indicate
Description
PWR/P1/P2
ON
Power is connected and
running normally
OFF
Power supply is
disconnected or running
abnormally
ALM
ON
Power supply or the port
link is alarming.
OFF
Power supply, port link
without alarm
RUN
ON
The device is powering on
or the device is abnormal.
OFF
The device is powered off
or the device is abnormal.
Blinking
Blinking 1 time per
second, the device is
running normally.
Link/Act
(1-8/9)
ON
Ethernet port has
established a valid
network connection
Blinking
Ethernet port is in an
active network status
OFF
Ethernet port has not
established valid network
connection
The left light 1
is on
The WiFi function of this
device is enabled
The left light 1
is off.
The WiFi function of this
device is disabled
The right light
2 and 3 are off
The device is in AP mode;
Or the device is in bridge
mode, but the bridging is
unsuccessful.
The right light
2 or 3 is on
The device is in bridge
mode, and the bridge
signal strength is weak
The right light
2 and 3 are on
The device is in bridge
mode, and the bridge
signal strength is strong
【
Logging in to WEB Interface
】
Support WEB management and configuration. Computer can
access the device via Ethernet interface. The way of logging
in to device’s configuration interface via IE browser is shown
as below:
Configure the IP addresses of computer and the
device to the same network segment, and the
network between them can be mutually accessed
Enter device’s IP address in the address bar of the
computer browser.
Enter device’s username and password in the login
window as shown below.
Click “OK” button to login to the WEB interface of
the device.
Note:
The default IP address of the device is “192.168.1.254”.
The default user name and password of the device are
“admin”.
If the username or password is lost, user can restore it to
factory settings via device DIP switch or management
software; all modified configurations will be cleared
after restoring to factory settings, so please backup
configuration file in advance.
Please refer to user manual for specific configuration
method of logging in to WEB interface and other
configurations about network management function.
【
Specification
】
Panel
100M copper port
10/100Base-T(X) self-adapting
RJ45 port, half/full duplex
self-adaption or forced working
mode, support MDI/ MDI-X
self-adaption
100M fiber port
100Base-FX, 1×9 interface
Console port
CLI command management
port (RS-232), RJ45