4.3.2 Set Time of Day
The user can also set the time of day. Time should only need to be set after extended power outages or
when daylight saving time begins or ends. If an extended power outage occurs, the time of day will flash
on and off which indicates the time of day should be reset.
Step 1 - Press SET CLOCK.
Step 2 - Current Time (hour): Set the hour of the day using / button. AM/PM toggles after 12. Press
NEXT to go to step 3.
Step 3 - Current Time (minutes): Set the minutes of the day using / buttons. Press NEXT to exit Set
Clock. Press REGEN to return to previous step.
Note: If time of day is set incorrectly, the time set for regeneration process may be affected.
4.4.1 Sometimes there is a need to regenerate the system sooner than when the system calls for it,
usually referred to as manual regeneration. There may be a period of heavy water usage because of
guests or a heavy laundry day.
To initiate a manual regeneration immediately, press and hold the “REGEN” button for five seconds. The
system will begin to regenerate immediately. The request cannot be cancelled.
4.4.2 To initiate a manual regeneration at the present delayed regeneration time, press and release
“REGEN”. The words “REGEN TODAY” will flash on the display to indicate that the system will regenerate
at the preset delayed regeneration time.
4.4 Manual Regeneration
Note: For softeners, if brine tank does not contain salt, fill with salt and wait at least
two hours before regenerating.
Note: If you pressed the "REGEN" button in error, pressing the button again will
cancel the request.
