3M SCOTT AIR-PAK X3 PRO, Инструкции по осмотру и очистке

Страница: 25 / 56

P/N 595360-01 Rev G 202004 25
CHAPTER 2
SOFT GOODS ASSEMBLY & DISASSEMBLY
This chapter provides instructions for detaching the soft goods (shoulder harness, waist pad, and straps) from the
backframe (in preparation for laundering or replacement) and reattaching them to the backframe.
•
“ Detaching the Shoulder Harness and Waist Pad ” on page 25
•
“ Attaching the Shoulder Harness and Waist Pad ” on page 32
Detaching the Shoulder Harness and Waist Pad
You can detach the shoulder harness and waist pad from the backframe without any tools.
To detach the shoulder harness from the backframe
1 Open the lower and upper flaps of both shoulder pads by unfastening the snap closures. See Figure 2-1 .
Figure 2-1 Opening the upper and lower shoulder pad flaps
CAUTION
Before detaching the shoulder harness or waist pad, be sure to shut off the respirator and remove the
breathing air cylinder as outlined in the operating and maintenance instructions provided with your 3M Scott
Air-Pak SCBA.
NOTE
If you have installed the 3M Scott Air-Pak X3 Pro SCBA chest strap accessory, uninstall it as directed in
Chest Strap Accessory for the 3M Scott Air-Pak X3 Pro SCBA: Installation and Use Instructions (P/N
595366-01) before detaching the shoulder harness from the backframe.
Lower flap
Upper flap
P/N 595360-01
202004
Rev G