The Sound Solution
6
2.4 BASE/PORTABLE UNIT
2.4.1 SWITCHING A BASE/PORTABLE UNIT ON
•
Switch a base unit on by pressing the [
M
] button.
In a headset, connected in the headset connector on the unit, a voice confirmation
“BASE, POWER ON”
is given and the
LED
(light emitting diode) is flashing, showing that the base unit is setting up the system.
Notice:
Initially, a base/portable unit is starting up as a base. (See also
ALTERNATIVE OPERATION MODES OF BASE/PORTABLE UNITS below.)
After approximately 20 seconds, the system is ready and a voice message
“GROUP 1”
is given. The
LED
on the unit is flashing
slower, showing that the base unit is ready for use and portable units can be logged on. (The LED can be switched off with use
of special DECT-Com II software.)
2.4.2 SWITCHING A BASE/PORTABLE UNIT OFF
•
Switch a base unit off by pressing and holding the [
M
] button for approximately 2 seconds.
A voice confirmation
“POWER OFF”
is given, the
LED
is unlit, and the unit is turned off.
2.4.3 ALTERNATIVE OPERATION MODES OF BASE/PORTABLE UNITS
By different start-up sequences the
base/portable
main units can be set up to work either as a base or as a portable unit.
2.4.3.1 STARTING A BASE/PORTABLE UNIT AS A PORTABLE UNIT
•
Switch the unit on by pressing and holding the [
M
] and [
–
] buttons simultaneously for approximately 2 seconds.
In a headset, connected in the headset connector on the unit, a voice confirmation
“POWER ON”
is given,
confirming that the unit is started as a portable unit.
After approximately 15 seconds, the unit is ready and a voice message
“BASE #, GROUP 1”
is given. The
LED
on the unit is lit, showing that the unit is ready for use as a portable unit, and is logged on to base No. #.
(The LED can be switched off with use of special DECT-Com II software.)
Notice:
All units are always started in listen only mode in group 1.
Last used alternative (base or portable) is remembered between sessions.
2.4.3.2 STARTING THE UNIT AS A BASE UNIT
•
Switch the unit on by pressing and holding the [
M
] and [
+
] buttons simultaneously for approximately 2 seconds.
In a headset, connected in the headset connector on the unit, a voice confirmation
“BASE, POWER ON”
is given,
confirming that the unit is started as a base unit.
After approximately 20 seconds, the system is ready and a voice message
“GROUP 1”
is given. The
LED
on the
unit is flashing slower, showing that the base unit is ready for use and portable units can be logged on.
(The LED can be switched off with use of special DECT-Com II software.)
A user with a headset connected in the headset connector on a base unit can also be participating in a
DECT-Com II conference, similar to a portable unit. (See also parts 3, 4 and 6.)
Notice:
All units are always started in listen only mode in group 1.
Last used alternative (base or portable) is remembered between sessions.
2.4.4 MAKING A BASE UNIT READY FOR PORTABLES TO BE REGISTERED
Each portable unit should be registered to a base unit to be part of a DECT-Com II conference.
•
With the base unit in
LISTEN-ONLY
and
VOLUME
mode, double press on the [
M
] button to enter
REGISTRATION
mode.
A base unit in
REGISTRATION
mode is indicated by slow flashing
LED
.
•
When all portable units are registered to the base unit, exit
REGISTRATION
mode by briefly pressing [
MODE
] button.
