22
3M™ MicroTouch™ Display C1500SS Installation Guide
3M Touch Systems Proprietary Information
Display Installation Problems
No image displayed
(blank screen)
Is the display receiving power?
•
Check that the computer’s power cable is connected properly and
securely into a grounded electrical outlet.
•
Check that the AC input jack is firmly plugged into the display.
•
Check that the display’s power cable is connected properly and
securely to an electrical outlet.
•
Try using another power cable.
•
Try using another electrical outlet.
Is the display receiving a valid video signal from the PC?
•
Check that the computer is powered on.
•
Check that the video cable is connected properly and securely to the
display and the computer.
•
Check that the LED on the rear of the unit is green.
•
Check that no pins are bent in the video cable connector.
•
Check that the video card is firmly seated in the card slot in your
computer.
•
Check that the video input from the video card falls within the refresh
rate of the display. Refer to Table 1 for details.
•
Check that your computer is using a supported display mode. Refer to
Table 1 for details.
Is the display in Power Management mode?
•
If the LED on the rear of the display is flashing orange/red, touch the
screen, press any key on the keyboard, or move the mouse to restore
operation.
Are the brightness and contrast settings too low?
•
Use the display controls to adjust these values.
Abnormal image
•
Check that the video input from the video card falls within the refresh
rate of the display. Refer to Table 1 for details.
•
Check that the video cable is connected properly and securely to the
display and the computer.
Colors of image are
abnormal
•
Check that the video cable is connected properly and securely to the
display and the computer.
•
Check that no pins are bent in the video cable connector.
Disturbances on the
screen
•
The video display adjustments are incorrect. Refer to Chapter 4 for
adjusting procedures.
Содержание MicroTouch CT150
Страница 16: ......