6
EN
(English)
f.
When the battery is charged
▪
Disconnect the charger from the power outlet.
▪
Unplug the charger from the
3M™
Clean-T
race™
LM1 Luminometer.
g.
The battery level indicator
▪
The battery level indicator is located at the upper right corner of the screen.
▪
When a 3M Clean-Trace Luminometer is on, the indicator shows the remaining battery level.
▪
As the battery charge decreases, the filled segment of the indicator becomes smaller as well as does the
number indicating the percentage charge.
▪
When the battery level is less than 20%, a notification will display, showing the
battery should be recharged.
▪
When the battery level is less than 10%, the indicator becomes red, showing the
battery should be recharged.
▪
When the battery level is less than 5%, the 3M Clean-Trace Luminometer
automatically shuts down.
h.
Power management
The 3M Clean-Trace Luminometer conserves battery power if the device is not in use.
▪
After 5 minutes of inactivity, the 3M Clean-Trace LM1 Luminometer goes into Sleep mode and the screen
darkens. This time can be customized, refer to
Changing sleep timeout
section.
▪
After 2 additional hours of inactivity, the 3M Clean-Trace Luminometer automatically shuts down and must be
powered on again before use. Refer to the Switching the Power on section of this User manual for more
information.
The LM1 battery indicator shows
the remaining battery level
The LM1 battery indicator shows
charging through a computer
The LM1 battery indicator shows
charging through a power outlet
This is the indication of a depleted battery and no charging source detected.
This will display for approximately 5 seconds then the unit will shut down.
Connect the LM1 to the charger now
This is the indication of a depleted battery with charging source detected.
This will display for approximately 5 seconds then the unit will shut down.
This is the indication of battery level going under 20%.
Tap
[OK]
to acknowledge
Connect the LM1 to the charger as soon as possible
