FORM NO: SIT 5908279
REV: B
3
•
To reduce the risks associated with working at height which, if not avoided,
could result in serious injury or death:
-
Your health and physical condition must allow you to safely work at height and to
withstand all forces associated with a fall arrest event. Consult your doctor if you
have questions regarding your ability to use this equipment.
-
Never exceed allowable capacity of your Fall Protection equipment.
-
Never exceed the maximum free fall distance specified for your Fall Protection
equipment.
-
Do not use any Fall Protection equipment that fails inspection, or if you have
concerns about the use or suitability of the equipment. Contact 3M Technical
Services with any questions.
-
Some subsystem and component combinations may interfere with the operation of
this equipment. Only use compatible connections. Contact 3M Technical Services
before using this equipment in combination with components or subsystems other
than those described in these instructions.
-
Use extra precautions when working around moving machinery, electrical hazards,
extreme temperatures, chemical hazards, explosive or toxic gases, sharp edges,
abrasive surfaces, or below overhead materials that could fall onto you or your Fall
Protection equipment.
-
Ensure use of your product is rated for the hazards present in your work
environment.
-
Ensure there is sufficient fall clearance when working at height.
-
Never modify or alter your Fall Protection equipment. Only 3M, or persons
authorized in writing by 3M, may make repairs to 3M equipment.
-
Before using Fall Protection equipment, ensure a written rescue plan is in place to
provide prompt rescue if a fall incident occurs.
-
If a fall incident occurs, immediately seek medical attention for the fallen worker.
-
Only use a full body harness for Fall Arrest applications. Do not use a body belt.
-
Minimize swing falls by working as directly below the anchorage point as possible.
-
A secondary Fall Protection system must be used when training with this product.
Trainees must not be exposed to an unintended fall hazard.
-
Always wear appropriate Personal Protective Equipment when installing, using, or
inspecting the product.
-
Never work below a suspended load or worker.
-
Always maintain 100% tie-off.
