3M AccuGlide HST 39100, Инструкция и перечень запасных частей

Страница: 24 / 39

20
Figure 6-2 – Lubrication
CAUTION – WIPE OFF EXCESS OIL AND GREASE: IT WILL ATTRACT DUST AND DIRT WHICH
CAN CAUSE PREMATURE EQUIPMENT WEAR AND JAMMING. TAKE CARE THAT OIL AND
GREASE ARE NOT LEFT ON THE SURFACE OF ROLLERS AROUND WHICH TAPE IS THREADED, AS
IT CAN CONTAMINATE THE TAPE’S ADHESIVE.
Maintenance (Continued)
Lubrication
Refer to Figure 6-2
Like most other equipment, the taping head must be properly lubricated to insure long, trouble free service.
Figure 6-2 illustrates points which should be lubricated every 250 hours of operation. Lubricate the rotating
and pivoting points noted by the arrows (
) with SAE #30 non-detergent oil. At the same time, a small
amount of multipurpose grease should be applied to the guides and to the end of each spring where the loop is
secured at an eyelet, post, or hole noted by arrows (
).