3M 3M-Matic 7000r, Инструкция и перечень запасных частей

Страница: 61 / 192

NA - ENG
April 2016
3M-Matic ™ 7000r-7000r3 Pro
Page 49
Figure 13-9
13.12 Special Set-Up Procedure for
Outer Column Re-Positioning
( continued )
Moving the outer columns
will increase or decrease the
box height handled by the
7000r-7000r3 Pro case sealer.
Maximum Height:
An additional adjustment can be
made to reach Maximum Height.
This additional height adjustment
can be made by moving the
Upper Assembly Crossbar up
to top holes - (Figure 13-9).
Box Height Range – (Refer to
Figure 13-8 / Section 7 / and
Speci fi cations )
The operating range of the upper
drive assembly can be adjusted to
minimize its movement (which
increases the operating speed) and
in conjunction with adjusting the
bed height, to change the range of
box heights being sealed.
After establishing the minimum
box height to be sealed, position
the stop bumpers as follows:
1. Latch upper drive assembly in
upper position, turn o ff air and
electric.
2. Remove and relocate the stop
bumper assembly to the desired
position on both side columns.
Be sure that the stop bumpers are
reassembled as shown and secure
(Figure 13-7 and Figure 15983) .
3. Turn on the air and electrical
power to the case sealer.
The upper taping head will now
descend only part way thus
increasing operating speed.
• To reduce the risk associated with
mechanical and electrical hazards:
- Turn peumatic and electrical supplies off
and disconnect before performing any
adjustments, maintenance or servicing
the machine or taping heads.
• To reduce the risk associated with
muscle
strain:
− Use the appropriate rigging and
material handling equipment when
lifting or repositioning this equipment
• To reduce the risk associated with
impact
hazards:
− Always use appropriate supporting
means when working under the
upper drive assembly
WARNING
WARNING
13. Maintenance and Repairs
(continued)