3M 26778, Руководство пользователя, Страница: 18 / 576

16 16
Connecting Pressurized Hose
1� Connect pressurized paint or coating supply
hose to bottom threaded fitting of pressure
fluid hose connector by wrench tightening
with two wrenches in the locations
shown below�
Disconnecting Pressurized Hose
1� Release Pressure from paint or coatings
supply hose�
2� Disconnect pressurized paint or coating
supply hose from bottom threaded fitting of
the pressure fluid hose connector by wrench
loosening with two wrenches in the locations
shown below�
Note: Use of a shut off valve is recommended
(sold separately: 3M™ Performance Spray Gun
Ball Valve - 26839)
Adjusting the Fan Pattern Size
The fan size is regulated by the fan adjustment
knob� The spray gun in the kit is preset in the
closed position (gently turn the fan adjustment
knob clockwise to verify; knob should not move)�
Next, turn the knob counter-clockwise 2 rotation�
The fan adjustment will allow you to spray from a
small round to a full fan pattern�
Adjusting the Fluid Flow
The fluid flow can be adjusted by using the fluid
needle adjustment knob� The spray gun in the
kit is preset in the
closed
position (pull trigger
to verify; there should be minimal fluid needle
movement)� To allow fluid flow, gently turn the
fluid needle adjustment knob counter-clockwise
4 full turns� These adjustment procedures will
serve only as a starting point� Fine tuning of
these adjustments will be based on your material
and technique�
Fan Adjustment
Knob
Fluid Needle
Adjustment
Knob
The spray pattern can be changed from vertical
to horizontal by rotating the air cap a 1/4 turn�
HORIZONTAL PATTERN
VERTICAL PATTERN