3Jtech G2Wifi II Скачать руководство пользователя страница 1

Страница: 1 / 8

Ver 1.0.0.0

Quick Installation Guide for G2wifi II

G2wifi II Connection

G2wifi II, a WLAN Access Point with the built-in modem, has failover function using dial-up

modem. Not only can it be used as a regular router to connect to ADSL / Cable modem but also

as a PPP router using dial-up modem to connect to the ISP. Please use the procedures below

for step-by-step instructions to set up your G2wifi II.

Hardware Connection Settings

1) Connect XDSL/Cable to the WAN port of your G2wifi II using a RJ-45 cable.

2) Connect PC to LAN port of your G2wifi II using a RJ-45 cable.

3) Make sure the SIM card has inserted to the modem, and the modem is ready as well.

4) Connect the power cable to the power connector of your G2wifi II.

Содержание G2Wifi II

Страница 4: ...heck the box Enable Dialup WAN and select the modem type After finishing the above procedures select the following steps for further settings according to your type of the Dial up modems as we have mentioned above Set up the G2wifi II for GPRS 3G 3 5G HSDPA or EDGE modem 1 In this case please select GPRS ...

Страница 6: ... device has rebooted properly You can check if the switch is online by clicking on the STATUS The information should be displayed under the WAN section Set up the G2wifi II for CDMA EVDO modem 1 In this case please select CDMA ...

Страница 7: ... is the time for On Demand mode to disconnect when the modem is idle 3 In CDMA ISP SETTINGS please contact your ISP for the CDMA online settings User must enter the CDMA Dial Command Username and Password Besides you must enter PIN code if you had set up before for the SIM card 4 Click on Save Settings after completing the setup Please ask your ISP for required information ...