3Dlabs Workstation x1000, Руководство пользователя

Страница: 30 / 59

SOFTWARE CONFIGURATION
Enabling stereo display
If you connect a device to the stereo port on the Wildcat III 6210 or Wildcat III 6110, you must change
the display mode to view in stereo. See
Chapter 2, “Setup,” for an illustration of the stereo output port.
1. Make sure your stereo display device is properly connected to the stereo output port on the
Wildcat III 6210 or Wildcat III 6110. See Chapter 2, “Connecting a Stereo Display
Device” for more information.
2. On the Wildcat III Monitor tab under Display Properties, click Configure Monitor. The
Configure Monitor dialog box displays.
3. Select one of the Stereoscopic Display modes from the Display Mode pulldown, then click
OK to return to the Display Properties dialog box. If you are prompted with the following
message: “The selected monitor cannot display the current desktop area. Select a new
resolution before applying these changes,” click OK then select a resolution from the list of
available resolutions.
4. Click OK if the display is correct and you wish to keep the new settings. The Display
Properties dialog box is dismissed.
5. Click OK to accept the new display mode and dismiss the Display Properties dialog box.
NOTE: You must disable stereo mode when you no longer wish to view in stereo. Follow
the steps above, and select Monoscopic Display under Display Mode to disable
stereo mode.
Enabling Multiview and Genlock on the Wildcat III 6210
The Wildcat III 6210 comes with Multiview support for frame locking and rate locking of multiple
workstations. Genlock support allows video timing to be synchronized to an external timing source.
NOTE: Your application must support Multiview for Multiview to work. Refer to the Wildcat
support area on http://www.3dlabs.com/support/troubleshooting/wc-01.htm for
information on ordering the correct cables.
IMPORTANT: Multiview on a Wildcat III 6210 is not compatible with Multiview on any
previous Wildcat product. Only connect Wildcat III 6210 cards together in a
Multiview configuration.
Enabling Multiview features
1. Insert one end of a shielded DB-9 cable into the Multiview Out port of the first
workstation. This workstation becomes the “Master.”
2. Insert the other end of the cable into the Multiview In port of the second workstation. This
workstation becomes a “Slave.”
3. If connecting more than two workstations, continue linking workstations to one another by
connecting the Multiview Out port of one workstation to the Multiview In port of the next.
The last workstation should terminate the links and only have a cable plugged into the
Multiview In port.
3Dlabs Graphics Accelerator Card User's Guide 24