Rudder control horn
Your Slick is equipped with two rudder servo locations.
If you use a lightweight engine, such as most 50CC singles, use the forward rudder servo location
in the fuselage and the pull-pull cables. If you are using a larger engine such as 58-70CC you can
use the rear servo location and pushrod to move the CG back if required. Both positions are
illustrated below:
Pull-Pull style horn-
The rudder pull-pull control horn is installed in a similar fashion, except that it is double-sided. Remove
the covering on both sides of the rudder over the slots as you did for the elevators and ailerons, apply
epoxy to the center of the two horn pieces, and install into the rudder. Use alcohol to clean any excess
epoxy and temporarily insert two 3mm bolts through the holes in the horn to ensure alignment while the
glue cures.
