3dscentral.3dsystems.com
8
1.
Close the top cover, then select
VACUUM
on the LCD menu.
Open the cover. The vacuum starts.
2.
Vacuum the following areas:
•
The top of the Fast Axis; also reach inside to vacuum
the Rails and the Printhead Carriage.
•
The Build Bed (but not the Feeder side).
•
The deck around the Build Bed.
Note:
Be careful not to vacuum inside the service sta-
tion itself.
3.
Press the Control Knob once to turn off the vacuum.
6.2 Empty The Debris Separator
1.
Pull the Debris Separator out
of its holder on the printer.
2.
Empty the contents into a
trash receptacle.
3.
Use the soft brush found in
the Accessory Kit to brush
caked on powder from the
screen.
4.
Return the empty Debris Sep-
arator to its holder. Be sure to push the Separator flat
against the panel for a secure fit.
6.3 Clean The Rails and Carriage
1.
Pull the Fast Axis out toward you.
2.Using a paper towel dampened
with distilled water, wipe the top
and bottom Rails. Move the Car-
riage back and forth as needed to
clean the entire length of both
rails.
3.Using a clean, dry paper towel,
thoroughly dry both Rails.
4.
Using a fresh paper towel, wipe the Carriage to remove any
powder. Also clean the Build Bed and Deck.
6.4 Clean The Service Station
Before you begin:
•
Get several dry paper towels and a cotton swab.
•
Get the squirt bottle filled with distilled water.
•
Wear disposable gloves.
•
Get the Pick and Syringe from the Accessories Kit.
