Touch X
©2018 3D Systems Inc. All rights reserved. The 3D Systems logo and stylized text are registered trademarks of 3D Systems Inc.
All other trademarks are the property of their respective owners.
™
1
Download and Install drivers
Remove device from packaging
Connect and power up device
Run Touch Smart Setup
Perform verification tests
Save configuration
Download the Touch Device Driver from
www.3dsystems.com/haptics-devices/
touch-x/documents
.
Follow the Install
Wizard instructions to install the Touch
Device Drivers. Reboot your computer
after installing drivers to avoid any
performance issues.
Grab the polybag and remove the device
from the packaging. Lift the device out of
the foam by grasping the back and secur-
ing the rotating head as shown above.
DO NOT
lift the device by grasping the
stylus or arm (this can damage the device).
Connect the power cord to the power sup-
ply and to an available outlet. Then plug in
the power supply to the device. The LED at
the top should quickly blink twice.
Connect the provided USB cable to both
the device and the host computer.
After connecting the device, run the
Touch Smart Setup
application. To
calibrate the device, slowly move the arm
to the right and left, up and down, in and
out. Indicator boxes will turn
green
when
each axis is calibrated.
Perform the steps presented in the Sphere
Simulation and Hollow Cube Simulation
tests to verify proper device performance.
When these tests have been completed,
select
Save Configuration
to complete
the Touch Smart Setup process.
2
3
4
5
6
NOTE: Geomagic Freeform or Geomagic Sculpt cannot be open while running the Smart Setup.
Phone:
1-978-494-8241
E
-mail:
Please refer to the 3D Systems Touch Device User Guide for installation, safety, and
proper operating and handling instructions. The User Guide can be found here:
www.3dsystems.com/haptics-devices/touch-x/documents
30-0432 Rev. A
Grip &
Lift
Secure
Joints
Arm
Stylus
To USB
Port
To Wall
Outlet
Connect
Power
Supply
