3D Systems, Inc.
2
GEOMAGIC TOUCH QUICK START GUIDE
This quick start guide is a high-level overview of the steps you need to take to install, connect, and start to use the Geomagic Touch
haptic device. For detailed information, see the
Geomagic Touch User Guide
available on the
http://support.geomagic.com
website.
EXISTING USERS:
Remove any previous version of the PHANToM Device Driver that is installed on the computer:
•
Win 7 or Win 8: Control Panel > Programs and Features > Uninstall a program
Delete all older setup files in the following location: C:\Users\Public\Documents\SensAble\
PERFORM THE FOLLOWING STEPS:
1. Go to
http://support.geomagic.com
to download and install the latest version of the Geomagic Touch Device Driver. (Go to
http://
support.geomagic.com
, from Products select Scanners and Hardware, then select the Touch device and Downloads).
2. After the device driver has installed, select the option in the installer to
Restart Your Computer
.
3. For a computer with no internet connection, follow the
Driver Installation
instructions found on page 2 of the Ethernet Adapter
manual (included with your adapter).
4. Connect the Ethernet Adapter, if you have not already installed the driver – wait a few minutes for the driver to be automatically
installed (you must have internet connection).
5. Connect the Geomagic Touch Device (Ethernet cable and power supply) as shown below. Connect the Ethernet cable to the
Adapter and then to either the
ETH 1
or
ETH 2
ports on the device. This is the 3D recommended connection. For alternative
connections check Appendix B: Alternate Connections in the Geomagic Touch User Guide.
6. Check the Network Status Indicator on the Windows 7 or 8 taskbar.
USB Port
Ethernet Adapter Port
ETH 1 or ETH 2
