3D Systems DMP Flex 350, Руководство пользователя

Страница: 23 / 120

3D Systems, Inc. 18 p/n: 15-D100, rev. D
2.6 Safety Interlocks
The Printer module safety interlocks are installed to prevent:
• Electrical shocks
• Exposure to heat
• Exposure to laser
If a safety interlock on the printer module detects an unsafe operational condition, the printer module will not start.
If a safety interlock device does not operate properly:
• Do not operate the DMP Factory 350 system
• Switch off the main power
• Contact the CSE for assistance at
https://support.3dsystems.com/s/contactsupport .
2.6.1 Stack Light
A stack light with four safety and error indication lamps are installed.
The four lamps are from bottom to top:
• White
• Green
• Orange
• Red
A. White
The white light indicates that the laser is active.
• The white light stays on as long as the laser is activated.
B. Green
The green light indicates that the PTM is in operation.
• In preparation for a print task or that a print task has ended
• Is in safe mode.
C. Orange
The orange light indicates that the PTM is in operation, but a warning is generated.
The orange stack light indicates a warning, perform the following:
• Check the warning and follow standard procedures.
• When a correction is not possible, request assistance from the engineer.
When the situation is corrected, continue the operation of the PTM.
If the situation cannot be corrected, request assistance from an Engineer.
D. Red
The red light indicates that the PTM is in operation and an alarm was activated by the software of the PTM or the safety PLC.
The red stack light indicates an alarm, perform the following:
• If the emergency off push button was not activated, follow standard procedures.
• If the emergency off push button was activated, request assistance from an Engineer.
When the situation is corrected, continue the operation of the PTM.
If the situation cannot be corrected, request assistance from 3D Systems