11
SECURE WIRING
Before flying, use zip ties to secure ESCs to the frame. Ensure that
all wires are secured so they will not become entangled in spinning
propellers, are not too tight around corners (no hard 90-180 degree
bends), and do not pull on the APM
or other components. Always
complete the pre-flight checklist
before takeoff
(
copter.ardupilot.com/wiki/checklist
).
ESCs and wiring secured with zip ties
Visit
copter.ardupilot.com
to learn about multicopter safety,
hardware and software configuration, using autonomous flight
modes, tuning, designing missions with waypoints and events,
troubleshooting, and more. Happy flying!
SUPPORT
For more information about software, firmware, and flight behaviors, visit
the APM Copter community documentation project at
copter.ardupilot.com
.
For customer support, contact us at
or call our
support line at
+1 (858) 225-1414
Monday through Friday, 8 am to 5 pm.
For more assembly instructions and information about building and
configuring your copter, visit
3drobotics.com/learn
.
Remove plastic rings from propeller package, select the one with the smaller internal
diameter, and insert it into the back of the propeller hub.
Add propeller to motor collet with writing facing up in
relation to the sky. Add the washer and prop nut above
the propeller; tightly fasten prop nut to threaded collet.
Prop nut
Motor
Propeller
Collet
Safety Check! Ensure writing on props faces up.
Washer
