3D Platform 3DP1000, Руководство пользователя

Страница: 11 / 32

www.3DPlatform.com | 9
Original Instructions 2015
Initial Setup
HEAT THE EXTRUDER
Preheat the extruder using your software and computer
interface, or by using the LCD control unit.
1. Press the button on the LCD Screen,
select Prepare , select Preheat PLA .
See detailed instructions for the LCD control unit
on
page 16 .
HEAT THE PRINT BED
Set the print bed heat to 70° C.
This is your initial bed temperature.
Additional heat may be necessary
depending on what print material
is used. Refer to the Recommended
Temperatures table on
page 13 .
A. Printers purchased prior to 12-4-15 have the
temperature control unit for the print bed located
on the front of the machine. The print bed control
operates independently.
B. Printers purchased after 12-4-15 operate the
temperature of the print bed through the LCD control
unit or with 3D printing software.
Note: Turning the bed heat on in the setup process will allow time to
reach optimal temperature.
° C
LOAD FILAMENT
Feed the filament through the filament guide loop.
Press and hold the bolt on the extruder to release
the hob while pressing firmly to insert the filament.
Hold the filament firmly and exert pressure until it begins
to extrude from the bottom of the nozzle. Make sure the
extruder is heated prior to loading filament.
REMOVE Z-STOPS
Z-Stops are used for holding the Z axis position during
shipping. Remove the (two) Z-Stops prior to homing.
Raise the Z axis slightly to remove the Z-Stops.
1. Press the button on the LCD Screen, select
Prepare ,
select Move Axis, select Move 1 mm, select Z Axis,
turn knob right to move Z axis up.
2. Raise the Z axis using your computer/software.