3Com V3000 ANALOG, Руководство по установке

Страница: 102 / 252

102 C
HAPTER
2: I
NSTALLING
S
YSTEM
H
ARDWARE
C
OMPONENTS
2 Record the existing IP settings on the computer so you can restore them
later and then change the IP settings of your computer to:
CAUTION: Do not set your computer address to 192.168.1.19 2 because
that IP address is used temporarily during system startup. If you use that
address for your computer, a conflict results and the system might not
start properly.
3 If your operating system requires a it, reboot the computer so that the
new settings take effect.
4 Start a browser.
5 Access the NBX NetSet utility by entering the NBX default address into
the browser’s address field:
192.168.1.190
After you press the Enter key on your keyboard, you should see the NBX
login screen. If the connection attempt fails, check the browser’s Proxy
Server setting and verify that it is configured for a direct connection. Also,
check the Connection setting and verify that it is set for a direct LAN
connection, not a dial-up connection.
6 After you have connectivity between the computer and the NBX system,
log into the NBX NetSet utility using the administrator username and
password.
7 Click System-wide Settings > IP Settings.
8 Edit the IP settings to conform to your LAN.
9 Click Apply to close the dialog box.
10 Click System Maintenance > Reboot/Shutdown .
11 Click Reboot.
Table 21 can help you determine if you need to make changes to the NBX
system default IP settings. To avoid address conflicts with devices on your
local network, change the IP settings of NBX system
before you connect
the system to the LAN.
IP address: 192.168.1.191
Default gateway: 0.0.0.0
Subnet mask: 255.255.255.0