3Com U.S. Robotics 56K Voice, Руководство пользователя

Страница: 40 / 168

40 C
HAPTER
3: B
EFORE
Y
OU
B
EGIN
Figure 24 Set Up Steps for Statically Configured Workstation
Setup Steps for a Static
Workstation
The first step is to record your current, statically-configured workstation’s network
settings and set them aside for later use. Then you must temporarily change your
statically-configured workstation’s network settings so that your workstation can
communicate with the LAN Modem. The parameters which must be changed are
your workstation’s
IP address , Subnet Mask and Gateway Address .
Follow the instructions for your operating system:
These instructions assume that the LAN Modem configuration is set to the factory
default. If you are moving the LAN Modem from a different LAN, reset the LAN
Modem before you begin. To do so, refer to “Resetting the Dual 56K LAN
Modem,” Chapter 10.
For Windows 95 and 98 Users
1 From the Start menu, select Settings and then Control Panel .
2 Double-click Network, and then select TCP/IP from the scroll-down list.
If you have multiple TCP/IP entries, select TCP/IP for the Ethernet card associated
with the Dual 56K LAN Modem.
3 Click Properties, and then click the Gateway tab. Write down the first IP address
listed under Installed gateways. You will reenter this information later.
4 Click the IP Address tab.
5 Write down the values listed in the IP Address and Subnet Mask fields. You will
need to reenter this information later.
Change Workstation
to Match LAN Modem
Record Workstation’s
Current Settings
Reset Workstation
to Original Static Settings
Launch Browser
Change LAN Modem
IP Address for Static LAN