3Com Switch 4800G PWR 24-Port, Руководство по настройке

Страница: 231 / 730

1-17
To do... Use the command... Remarks
Enable proxy checking function
globally dot1x supp-proxy-check
{ logoff | trap }
Required
By default, the 802.1x proxy
checking function is globally
disabled.
In system
view
dot1x supp-proxy-check
{ logoff | trap } [ interface
interface-list ]
interface interface-type
interface-number
dot1x supp-proxy-check
{ logoff | trap }
Enable proxy
checking for a
port/specified
ports
In port view
quit
Required
By default, the 802.1x proxy
checking is disabled on a port.
z
The proxy checking function needs the cooperation of H3C's 802.1x client (iNode) program.
z
The proxy checking function depends on the online user handshaking function. To enable the
proxy detecting function, you need to enable the online user handshaking function first.
z
The configuration listed in the above table takes effect only when it is performed on CAMS as well
as on the switch. In addition, the client version checking function needs to be enabled on the switch
too (by using the dot1x version-check command).
Configuring Client Version Checking
Follow these steps to configure client version checking:
To do... Use the command... Remarks
Enter system view system-view —
In system
view dot1x version-check [ interface
interface-list ]
interface interface-type
interface-number
dot1x version-check
Enable
802.1x client
version
checking
In port
view
quit
Required
By default, 802.1x client version
checking is disabled on a port.
Set the maximum number
of retires to send version
checking request packets
dot1x retry-version-max
max-retry-version-value
Optional
By default, the maximum number
of retires to send version checking
request packets is 3.
Set the client version
checking period timer dot1x timer ver-period
ver-period-value
Optional
By default, the timer is set to 30
seconds.