3Com SuperStack 4, Руководство по настройке

Страница: 112 / 432

124 C
HAPTER
6: IP R
OUTING
P
ROTOCOL
O
PERATION
Disabling Host Route
In some cases, the router can receive many host routes from the same segment,
and these routes are of little help in route addressing but consume a lot of
network resources. Routers can be configured to reject host routes by using the
undo host-route
command.
Perform the following configurations in RIP View.
By default, the router receives the host route.
Enabling RIP-2 Route Aggregation
Route aggregation means that different subnet routes in the same natural
network can be aggregated into one natural mask route for transmission when
they are sent to other networks. Route aggregation can be performed to reduce
the routing traffic on the network as well as to reduce the size of the routing
table.
RIP-1 only sends the routes with natural mask, that is, it always sends routes in the
route aggregation form.
RIP-2 supports subnet mask and classless inter-domain routing. To advertise all the
subnet routes, the route aggregation function of RIP-2 can be disabled.
Perform the following configurations in RIP View.
By default, RIP-2 uses the route aggregation function.
Setting RIP-2 Packet Authentication
RIP-1 does not support packet authentication. However, you can configure packet
authentication on RIP-2 interfaces.
RIP-2 supports two authentication modes:
■
Simple authentication — This mode does not ensure security. The key is not
encrypted and can be seen in a network trace, so simple authentication should
not be applied when there are high security requirements.
■
MD5 authentication — This mode uses two packet formats. One format
follows RFC1723, and the other follows RFC2082.
Table 119 Disabling Host Route
Operation Command
Enable receiving host route
host-route
Disable receiving host route
undo host-route
Table 120 Enabling Route Aggregation
Operation Command
Activate the automatic aggregation function of RIP-2
summary
Disable the automatic aggregation function of RIP-2
undo summary