3Com SuperStack 3 NBX, Руководство по началу работы

Страница: 47 / 84

Setting Up Command Line Interface Management 47
Figure 18 SNMP management over the network
Refer to “Setting Up SNMP Management” on page 49 .
Setting Up
Command Line
Interface
Management
This section describes how you can set up command line interface
management using a local console port connection or over the network.
CLI Management via
the Console Port
To manage a Switch using the command line interface via the local
console port connection:
1 Ensure you have connected your workstation to the console port correctly
as described in
“Connecting to the Console Port” on page 38 .
2 Your Switch is now ready to continue being managed and/or configured
through the CLI via its console port.
CLI Management over
the Network
To manage a Switch using the command line interface over a network
using Telnet:
1 Ensure you have already set up the Switch with IP information as
described in
“Setting Up Overview” on page 32 .
2 Check that you have the IP protocol correctly installed on your
management workstation. You can check this by trying to browse the
World Wide Web. If you can browse, the IP protocol is installed.
3 Check you can communicate with the Switch by entering a
ping
command at the DOS prompt in the following format:
c:\ ping xxx.xxx.xxx.xxx
(where xxx.xxx.xxx.xxx is the IP address of the Switch)
If you get an error message, check that your IP information has been
entered correctly and the Switch is powered up.
DUA1730-0AAA03.book Page 47 Thursday, November 17, 2005 12:17 PM