3Com SuperStack 3 4900 SX, Руководство по началу работы

Страница: 29 / 54

Setting Up Command Line Interface Management 29
To connect the cable:
a Attach the female connector on the cable to the male connector on
the console port of the Switch.
b Tighten the retaining screws on the cable to prevent it from being
loosened.
c
Connect the other end of the cable to your terminal, terminal
emulator, or modem. Make sure that the terminal, terminal emulator,
or modem have the same settings as the console port:
■
8 data bits
■
no parity
■
1 stop bit
To configure the settings of the terminal, terminal emulator, or modem,
see the documentation that accompanies it. If the Switch containing the
console port has auto-configuration enabled (default), the line speed
(baud) is detected automatically. The Switch can auto-detect a maximum
line speed of 19,200 baud.
3 Access the command line interface using a valid user name and
password. Default user names and passwords are described in
“Logging
in as a Default User” on page 33 .
Setting Up Over the
Network
To manage a Switch using the command line interface over a network
using Telnet:
1
Set up the Switch with IP information. To do this:
a Access the command line interface of the Switch through the console
port. See
“Setting Up Through the Console Port” on page 28 .
b Use the
protocol ip basicConfig
command to enter suitable
IP information for the Switch.
For more information about IP, see “Managing a Switch Over the
Network” on page 30 .
2 If you are using a terminal emulator, check that you have an IP stack
correctly installed on the terminal emulator.
3 Check that your terminal or terminal emulator is connected to the Switch
using a port that is in VLAN 1. By default, all ports on the Switch are in
VLAN 1.
17702ua.bk Page 29 Friday, April 6, 2001 3:31 PM