Before You Install Software
2-5
Figure 2-3
NIC LEDs at Power Up
Before You Install Software
Before you install a software driver, you may want to run
the Configuration and Diagnostic Program, as described in
Chapter 4
.
See the instructions in
Chapter 3
to install the driver from
the 3Com diskette. For information on LED states after the
software is installed, see
Table 4-1
in
Chapter 4
.
Be sure that the NIC hardware and software are installed
correctly before replacing the computer cover.
TX
TX
ACT
10
100
L
N
K
ACT: Off until the network driver is installed;
after driver installation, yellow indicates port traffic
10 LNK:
100 LNK:
Green indicates 10 Mbps link integrity
Green indicates 100 Mbps link integrity
ACT
10 LNK
100 LNK
