3Com OfficeConnect 3CR29210, Руководство по началу работы

Страница: 11 / 54

Configuring the TCP/IP Protocol 5
■
Cable Connections
TM
CD-ROM
■
This Getting Started Guide
Customer- and Service Provider-Supplied Items
Verify that you have these items available:
■
FOR ETHERNET INSTALLATION:
■
A PC running Windows ® 95 operating system (or
later)
■
A Macintosh ® computer running System 7.5 (or
later)
■
A network interface card (NIC) or active Ethernet
port
■
FOR USB INSTALLATION:
■
A PC running Windows 98 operating system (or
later)
■
An active USB port installed in your computer
■
TCP/IP protocol installed (see “Configuring the TCP/IP
Protocol” for more information on installing TCP/IP)
■
An active two-way cable line
■
An adjustable wrench for securing the cable line to the
cable modem
■
A screwdriver, drawing pins, and screws (for optional
wall-mounting). The screw heads should be at least
5mm in diameter so that they fit properly in the slot and
fasten the cable modem securely to the wall.
Configuring the TCP/IP Protocol
You must have the TCP/IP protocol installed and configured
on your computer so that the cable modem can connect to
your broadband Internet service.
NOTE: If you are using a Macintosh computer, see the
instructions on page 7.
Configuring the TCP/IP Protocol on a Windows PC
You need to make sure that either an active Ethernet port,
Ethernet network interface card (NIC), or an active USB
port and the TCP/IP communications protocol are installed
on your system before you install your cable modem.