50
C
HAPTER
4: I
NSTALLING
THE
N
ET
W
ARE
C
LIENT
AND
S
ERVER
D
RIVERS
Intelligent Auto Install Requirements
To use the intelligent auto install program:
■
Make sure that your PC has only one EtherLink PCI
NIC installed.
■
Make sure that you are using NetWare 3.x, 4.x, or 5.x as
your network operating system.
■
Make sure that your PC has at least 1 MB of available
hard drive space.
Running the Intelligent Auto Install Software
To run the intelligent auto install software to install the
client software and drivers for a NetWare network:
1 Install the NIC and connect it to the network, as
described in Chapter 2.
2 Reboot to DOS.
3 Insert the EtherCD in the CD-ROM drive.
4 At the DOS prompt, enter the following command,
where d is the drive letter of your CD-ROM drive:
d:install
The main menu appears.
5 Select Auto Install and Config for NetWare and
press Enter.
6 Select DOS, Windows 3.1x, or Windows for
Workgroups 3.11, and follow the instructions.
7 When the installation process is finished, remove the
EtherCD and reboot the PC.
If you are running Windows 3.1x, after you connect to
the NetWare server, run the WSINSTALL program for full
Windows support. Contact your system administrator for
the location of this NetWare utility.
book Page 50 Thursday, July 29, 1999 12:23 PM
