3Com CoreBuilder 9000, Руководство пользователя

Страница: 81 / 468

Setting the Port Network Connection Type 81
Setting the Port
Network
Connection Type
You can set the network connection type for a specified port or a group
of ports. To do this, you can use either the LMA or the integrated fast
setup. If you want to use the fast setup, see the
CoreBuilder 9000 ATM
Interface Module Getting Started Guide . You can set the interface type to
NNI, UNI, or GWY.
Setting the Network
Connection Type for a
Specific Port
You can configure the port network connection type.
Display Network Connection Type
Update Port Network Connection Type
Reset All Except IP Addresses
Display Network
Connection Type
Display the network connection type for each port of the
CoreBuilder 9000 ATM Enterprise Switch. The network connection type
may be Gateway (GWY), User to Network Interface (UNI), or Network to
Network Interface (NNI). When the port is connected to another ATM
Switch, the interface should be set to NNI. If it is connected to an edge
device such as an Ethernet to ATM device, or ATM attached server, the
interface type should be set to UNI.
Command Actions
Command Result
Enter the menu sequence:
(1) SYS: Platform Configuration
(1) SET: Switch Setup
(3) NNI: NNI Setup
(3) GIF: NNI Get Interface Type
Direct access sequence:
1 1 3 3
System action taken: The interface type for each port of the
CoreBuilder 9000 ATM Enterprise Switch is displayed.
System message display: Information is displayed as shown in the example.