3Com 5500G SERIES, Руководство по началу работы

Страница: 33 / 36

Installing the Linux System through an Ethernet Connection 33
/ # pxe_install
Try to do network install on eth1.....
Get the ip address from dhcp-server.....
udhcpc (v1.6.0) started
Sending discover...
Sending select for 10.10.10.91...
Lease of 10.10.10.91 obtained, lease time 21600
Get TFTP server IP address from DHCP by NextServer
The TFTP server IP address is: 10.10.10.10
Get config file setup/3CR17280-72/01-00-00-12-34-56-7
9.....Fail
Get config file setup/3CR17280-72/0A0A0A5B.....Fail
Get config file setup/3CR17280-72/0A0A0A5.....Fail
Get config file setup/3CR17280-72/0A0A0A.....OK
fdisk harddisk.....OK
mkfs of sda1.....OK
mkfs of sda2.....OK
mkfs of sda3.....OK
mkfs of sda5.....OK
mkfs of sda6.....OK
download vfat file(1.06/vfat.tar.gz).....OK
decompress vfat file(vfat.tar.gz).....OK
download disk file(1.06/disk.tar.gz).....OK
decompress disk file(disk.tar.gz).....OK
install hard disk OK
install completed
/ #
3 After the installation, execute the
reboot
command to reboot the
OSN|M:
/ # reboot
Do not interrupt the system while it is booting; until the following
messages appear.
Fedora Core release 6 (Zod)
Kernel 2.6.18.8 on an i686
localhost.localdomain login:
4 Enter the username and password to log into the Linux system.
A complete Linux file system is installed on the hard disk.
n
The first time you boot the system after an Ethernet installation, file
system checking occurs, which consumes more time than usual. Make
sure to wait until all system checking is complete before continuing.