background image

 

 

For a point-to-point association between two bridges, see “Setting up an Ad Hoc Network” 
in the User Guide.

 

 

For a point-to-multipoint association between an access point and one or more bridges, see 
“Setting up a Bridge to Access Point Network” in the User Guide.

For the latest networking information, see the 3Com Corporation World Wide Web site at: 

http://www.3com.com/.

 

7

Regulatory Information

 

Channel Selection in France

 

In France, this product must be configured to operate on a legal channel. Channels 10 - 13 are allowed. 
User documentation should be consulted to ensure that this product is used in accordance with local 
spectrum restrictions.

 

Additional Country Restrictions

 

 

In Israel, this product must be configured to operate on a legal channel. Channels 5 - 7 
are allowed.

 

 

In Jordan, this product must be configured to operate on a legal channel. Channels 10 - 13 
are allowed.

User documentation should be consulted to ensure that this product is used in accordance with local 
spectrum restrictions.

 

Safety Information

 

This equipment must be installed in compliance with local and national building 
codes, regulatory restrictions, and FCC rules. For the safety of people and 
equipment, only professional network personnel should install the bridge, cables, 
and antennas. 

 

WARNING:

 

 Do not install the bridge near overhead power lines, electric 

light or power circuits, or where it can come into contact with such 
circuits. Provide ten feet or more clearance between the bridge and such 
power lines or circuits. Do not install the bridge flush with the rooftop or 
wall. When installing the bridge, do not come into contact with such 
circuits, which can cause serious injury or death. Follow local and national 
codes for proper installation and grounding of antennas.

 

WARNING:

 

 To comply with FCC radio frequency (RF) exposure limits, 

antennas should be located at least eight inches (20 centimeters) or more 
from the bodies of all persons.

 

WARNING:

 

 Do not install the bridge or connect and disconnect cables 

during periods of lightning activity.

 

309-2273-001AA.fm  Page 7  Monday, February 3, 2003  4:54 PM

Содержание 3CRWEASY96A









Отзывы: