10/100BASE-TX F
AST
E
THERNET
M
ODULE
I
NSTALLATION
G
UIDE
5
6
Tighten the captive screws to secure the module in the chassis.
Figure 2
Installing the 10/100BASE-TX Module
After you have installed the module, see Chapter 4:
Cabling the System
in
your
Getting Started Guide
for information about cabling your module to
the network.
The system resets itself when you install a module with the power on or
when you remove and reinstall the power cord.
If you physically change the configuration of the system after you have
defined an IP interface, the port designated for that interface may no
longer be valid. You may need to redefine the interface using the
ip interface define
command. For details about this command,
see the
Command Reference Guide
. For additional information about
defining IP interfaces, see your system’s
Implementation Guide
. These
documents are on the Software and Documentation CD.
RUN
SYS
INS
PS1
PS2
FAN
R
N
S
TEMP SERVICE
INS
PCMCIA
MODEM
TERMINAL
ETHERNET
10BT
PWR
ERROR
1X
L E T
2X
L E T
3X
L E T
4X
L E T
5X
L E T
6X
L E T
100 BASE - TX
3C54321
PWR
INS
ERR
R
Captive screw
100BASE-TX
module
Injector/Ejector handle
