Setup Procedure
27
4
Select the Adapters tab.
The Select Network Adapter window displays.
5
Go to the section “Setup With No Networking Installed” in this chapter for
instructions if the message “networking is not installed” displays, .
6
Click
Have Disk
...
7
Insert the
LAN Installation Disk
in the floppy drive and click
OK
or insert the
LAN
Installation CD
into the CD-ROM drive (change the path to the drive, for example,
d:\) and click
OK
.
8
Select
FE575C-3Com 10/100 LAN CardBus-Fast Ethernet
when the Select OEM
Option window opens and click
OK
.
9
Accept the default settings in the network Settings window and click
Continue
.
10
Wait while the files are copied to your notebook.
The default settings work in most instances. However, you may specify network
link settings, auto polarity, and IRQ and I/O values. Please see the Working
Configurations directory on the Installation CD.
11
Click
Close
.
12
Enter your IP address if prompted and click
OK
.
13
Click
Yes
to the DHCP prompt, if the prompt displays.
14
Click
Apply
.
15
Click
OK
.
16
Remove the
LAN Installation Disk
from the floppy drive or the
LAN Installation CD
from the CD-ROM drive when prompted to reboot the notebook and click
Yes
.
Installing with Softex
For OmniBook 4150, 900, and XE2 users, please read the following procedure before
installing the 3Com 10/100 LAN CardBus PC Card using Softex Card Executive.
1
Make sure the driver diskette is removed from the notebook floppy drive.
2
Insert the 3Com 10/100 LAN CardBus PC Card into the PC Card slot.
Card Executive will attempt, but fail, to find the diskette.
3
When prompted, select
Install driver provided with PC Card
.
4
Type the following path and click
OK
:
a:\softex
The Network Settings window will display.
5
Select Continue.
The Protocol configuration window will display, depending on the protocol that
was chosen.
6
Reboot your system when prompted.
The PC Card is now installed.
