18
C
ONFIGURING
Y
OUR
O
FFICE
C
ONNECT
NETB
UILDER
10 B
RIDGE
/R
OUTER
d
Click Apply.
5
Enable all paths on port 4.
a
In the Dial On Demand ISDN Setup section of the
navigation frame, click the PATH CONTrol link.
b
In the start field, click the arrow and choose 2.1
c
In the end field, click the arrow and choose 3.
d
In the CONTrol field, click the arrow and choose
Enabled.
e
Click Apply.
6
If your line speed requirements are different than the
default (64 Kbps), you need to modify your path baud rate
configuration.
a
In the Dial On Demand ISDN Setup section of the
navigation frame, click the PATH BAud link.
b
In the start field, click the arrow and choose 3.
c
In the BAud field, enter your path baud rate. For
example, enter:
128
d
Click Apply.
Configuring Dynamic Dial
To configure Dynamic Dial, follow these steps:
1
Set the normal bandwidth of the port to the same baud
rate as you set for the path in the preceding procedure.
a
In the Dial on Demand Dynamic Dial section of the
navigation frame, click the PORT NORMalBandwidth
link.
b
In the start field, choose 4.
c
In the NORMalBandwidth field, enter your port baud
rate. For example, enter:
128
d
Click Apply.
OC10.book Page 18 Thursday, May 13, 1999 2:33 PM
