Insert 5/8” X 3” bolt
12
through the disk
13
. Place small
shim washer then fender washer over the bolt. Insert
bushing
14
(large side first) and hose guide assembly
15
(ear
tab
16
facing in).
Slide bolt of the disk assembly into the lower hole on the
bandit
12
, aligning the ear tab
16
with corresponding upper
hole and secure with lock nut.
Tighten with 15/16” socket and wrench. Check to ensure
that the disk freely turns. If the disk does not freely turn,
back off the lock nut slightly until the disk freely turns.
Using a mallet, install provided dust caps over disk bolt
heads.
Route application hose through hole in top of 360 BANDIT
frame
17
.
Repeat for other side.
Using side-cutters, cut the two hose guides apart
9
.
Route the hose through the top two holes in the hose guide
10
.
Hose guides are labeled
“L”
left and
“R”
right
11
.
NOTE: When installing hoseguides on the row unit, left and
right are determined from the operators seat.
6
Insert one of the longer 1/2” bolts
6
through the rock
guard
7
and then through the front hole on the closing
system plate. Secure to the BANDIT unit.
Insert the second 1/2” bolt through the rear hole of the
closing system plate
8
and secure to the BANDIT unit.
Tighten both using 3/4” wrench and socket.
INSTALLATION INSTRUCTIONS
HARVEST INTERNATIONAL
STEP 3
INSTALL ROCK GUARD
STEP 4
PREPARE HOSE GUIDES
STEP 5
INSTALL DISK ASSEMBLY
PAGE 3
9
CUT
7
9
6
14
15
16
12
16
8
7
10
11
12
13
17
