2Wire HomePortal, Быстрая установка, Страница: 14 / 28

12
Note:
The HomePortal has an auto-crossover port. You do not need to use a special crossover cable or
make any changes to the configuration of your HomePortal, Ethernet hub, or switch. The HomePortal will
establish the type of port needed during setup.
1.
Connect the provided AC power adapter from the HomePortal’s
POWER
port to an electrical outlet.
The green
POWER
light on the front of the HomePortal should light up.
2.
Connect the provided Ethernet cable from the
LOCAL ETHERNET
port on the HomePortal to an open
port on the hub or switch.
3.
Connect the first computer’s Ethernet adapter to the hub or switch using an Ethernet cable.
4.
Using an Ethernet cable, connect any additional computers to the hub or switch.
5.
Connect one provided telephone cable from the
DSL
port on the HomePortal to the DSL wall jack.
6.
Connect the other provided telephone cable from the
LINE
port on the HomePortal to a telephone jack.
7.
Plug the hub or switch into an electrical outlet.
Check your connections
With your computer completely started, verify the
POWER
and
HOME NETWORK
indicator lights on the
front of the HomePortal are green. If they are not, see “Diagnosing connection problems” on page 20. The
BROADBAND LINK
indicator light will not turn green until the HomePortal software has been installed and
an Internet connection has been established.
Continue from here to Step 3 “Install the HomePortal Software” on page 14.
Network with Ethernet Hub or Switch
Computer has Ethernet adapter and you are using an Ethernet hub or switch