Remove the cover from the switch. Interconnect the switch and the
2N Lift1
®
/ 2N
®
audio unit with the cable included in the delivery.
SingleTalk
Connect the microphone and speaker from
2N Lift1
®
/ 2N SingleTalk
®
in the
point-switch. The speaker and microphone connectors are marked (SPK and MIC). Put
the connectors on the jumpers in the switch. The configuration is the same as in
2N
®
(also marked on the switch board). Pull the cables through
Lift1/ 2N SingleTalk
®
the holes.
Warning
Make sure that the 6-pin connection is correct to avoid product damage.
Make sure that the yellow wire is up (when viewing the audio unit).
Caution
In the case of a cable version of
, an
2N Lift1 / 2N SingleTalk
®
®
external microphone should be connected into the microphone input on
the cable-switch. If you do not have a cable version, this input should be
free.
