7
www.2MTechnology.net
2M Technolgy User Manual
INSTALLATION SPECIFICATION
I. Installation instruction
1. Remove the packages of the main case and door plates.
2. Face the panel of the main case down, put the right and left door plates (as shown in the figure) at the specified
places and put the fitting box aside.
3. Put the right I left door plates and main case close to each other erectly and fix them together with 8 fixing
screws of the fitting box with an allen wrench.
4. Insert the DB25 plugs of the main case into the corresponding DB25 sockets of the right / left door
plates separately.
5. Insert the 3-pin plug of the external power cable of the fitting box into the socket being at the bottom of the
outside of the door plate (Note: The power supply is only connected when the socket used for the external power
cable and that used for the main case cable are set at the same door plate).
II. Directions for use
1. After the Walk-through Metal Detector (WTMD) is installed, keep pressing “RES” of the keyboard until the
machine is started and the panel lights up;
2. The started Walk-through Metal Detector (WTMD) will perform self-inspection and the item displayed on the
panel will change and twinkle. When the displayed item stops twinkling, both the number of passed persons and
alarms will be “O”, meaning that the startup operation finishes.
Note: The Walk-through Metal Detector (WTMD) is available for customized settings based on different conditions and
requirements, see the “Operating specification” for the detailed setting.
