2 Copyright © 2018 Nortek Security & Control LLC
Outdoor Wireless Contact | Installation Instructions
Mounting the Sensor on a Flat Surface.
1. Loosen the cover screw and remove the
Sensor Mounting Plate.
2. Ensure that the Magnet Direction Marks
are aligned toward the desired magnet
location.
3. Screw the Mounting plate into the
desired surface.
4. Replace the Sensor onto the Mounting
plate and tighten the cover screw.
5. Secure the magnet into place.
Mounting the Magnet on a Flat Surface.
1. Ensure that the magnet marks are aligned
to the desired magnet location.
2. Mount the sensor into the desired
surface using the two screws.
Sensor and Magnet Mounting Distance
The preferred mounting distance between the Sensor and
Magnet is 1/4 inch.
The maximum gap is 2 inches.
Sensor and Magnet Mounting Height
Ideally, the Sensor and Magnet should be mounted on
surfaces of equal height.
When mounted at a level height, the 1/4” preferred mounting
height offset should be attained.
A height offset that exceeds 1/4” may decrease detection
capabilities.
Recommended Gap = 0.25"
Maximum Gap = 2"
Mounted Surface
Mounted Surface
Magnet
direction
marks
1/4”
Recommended
