25-Seven TVC-15, Быстрое руководство по установке

Страница: 4 / 8

Before we set anything up we need to make sure the TVC-15 and Voltair are running compatible
versions. More information about version compatibility can be found in the TVC-15 release notes, which
are located at
https://www.telosalliance.com/25-Seven/TVC-15 , or by contacting support. You can
email the Support Department at support@telosalliance.com , or by phone at 216-622-0247.
1. Preparing Voltair for Adaptive Enhancement
A. Voltair must be running the compatible version software.
Check the latest TVC-15 Release Notes for a guide on compatible versions. These can be found a
the following link
https://www.telosalliance.com/25-Seven/TVC-15 .
B. Ensure GPI Pins 11,12, and 24 are disconnected from Voltair as they will interfere with the TVC-
15’s operation.
C. On the Voltair use the front panel jog wheel to highlight “Enhancing”
D. Find “Test Enhancement Switching”, verify that it is disabled
2. Setting an IP on the TVC-15:
Next, setup the network connectivity. TVC-15 and Voltair should both be using Static IP addresses.
Otherwise when the devices renew their DHCP leases they could receive different addresses,
breaking connectivity. Setting a static address is identical between TVC-15 and Voltair, so step 1 can
be used to setup the network setting on both systems.
A. On the front panel, turn the jog wheel until “Network” is highlighted.
B. Find the “DHCP” field
C. Press the jog wheel and rotate till DHCP is “Disabled”
D. Set the IP address by highlighting “IP Address” and then pressing the jog wheel to enter a field.
E. Now Scroll until the desired number populates in the first octet.
F. Press the jog wheel again to move to the next octet, and scroll until the proper value. Repeat this
until the full IP has been configured
G. After entering the proper values, pressing the jog wheel will exit to the network menu.
H. Repeat this process for all the necessary fields (subnet mask, Gateway, DNS) for the network.
I. When finished with all fields press the ESC button to save and exit.
QUICK-START INSTALLATION GUIDE