Notes:
How to re-do a full scan
Manual tune
1. Just like Digital TV there are some areas where it may be difficult to get a
good DAB signal. Broadcasters are constantly improving DAB coverage, so
you should check coverage for your area.
2. You may also need to start a scan manually to update the list of stations for
one of the following reasons:
- New stations may become available from time to time.
- Stations close or can no longer be received (In the station list, invalid
stations are indicated with a question mark “
？
” in front of their name).
- If reception was not good for the original scan (for example the antenna was
not up), this may result in an empty or incomplete list of available stations.
- If you have poor reception of some stations causing the audio to break up,
you may wish to list only stations with good signal strength.
2. Press “<” or “>” to display a particular channel/frequency and press OK button
to tune to that channel/frequency. The display shows a live indication of the
received signal strength on the selected frequency.
Adjustments to your antenna will be manifested in
the received signal strength displayed.
To re-do a full scan, short press the MENU button to show the menu and then
press “<” or “>” button to select ' Full Scan'.
Press /OK button to confirm.
As well as the normal method of scanning, you can also manually tune to a
particular channel/frequency. This can be useful for adjusting your antenna to
achieve the best possible reception and scanning a particular channel to
update the station list.
1. Press MENU button and then press “>” to show the Manual tune submenu,
then press the OK button to enter.
DAB MODE OPERATION
Auto scan
DAB radio mode receives DAB/DAB+ digital radio and displays information
about the station.
1. Fully extend the telescopic antenna.
2. Switch the unit on by rotating the Power ON/OFF switch to ON position to
turn on the unit.
3. Rotate the Function Selector to DAB position to enter DAB mode.
For first time use or if the station list is empty, the unit automatically
performs a full scan to see what stations are available. The display will show
the scan progress and the total number of channels during scanning.
4. When the scan is complete, the unit will set the time and start playing the
first station on the station list.
5. To change the station, press “<” or “>” button to scroll through the list of
stations and press /OK button to tune to the displayed station. The
playing screen will be displayed with the new station's details.
6. If no stations are detected during the scan the display will show “Service not
available”.
EN
EN
11
12
