(A) Spray Nozzle
(B) Handle
(C) Tank Lid
(D) Product Cover
(E) Wired Control Cable Interface
(F) Fuse Knob
(G) On/Off Switch
(H) Wired Control Indication Light
(I) Wired Control Box
(J) Wired Control Cable
Before using the fog machine, you have to prepare Fog Liquid (not included). Then operate according to following
sequence.
1. Remove all the packages.
2. Carefully put this product onto a clean, flat and solid surface, close to the power socket.
3. Unscrew the lid on the tank by turning counterclockwise and pour the Fog Liquid inside. Do not spill Fog Liquid onto
the product body. Do not overfill. If liquid gets into the Fog Machine, leave it to be dry completely before plugging in.
Do not cut, pinch, or break the tube connected through the tank lid. Screw the lid clockwise to the tank tightly.
Always make sure there is enough Fog Liquid in the tank before using the Fog Machine.
4. Connect the wired control cable to the Interface at the back of the Fog Machine.
5. Connect the product with proper power socket.
6. Warm up time is approximately 4 – 5 minutes. When fully heated, the Wired Control Indication Light will turn on and
the Fog Machine will be ready to produce and spray fog.
7. Set the On/Off Switch to on position, nozzle will start spraying fog. Set to off position, spraying will stop.
8. Turn off the unit before refilling the fog machine.
9. Unplug the unit when not in use.
10. To refill the tank; turn off the unit, unplug and follow the directions in Step 3.
How to Use?
Names for Parts
A
B
E
C
D
F
J
H
G
I
